Things so far...
Animation (5) Aquaponics (338) Bread (15) Cheese (14) cooking (49) electronics (57) Epic adventurer (20) Escargot (2) Fire (6) Fraudster (1) Handmade fishing lures (31) Home made preserves (11) Making smoked foods (11) Mold making (7) Movie watcher and critic (2) Photography (17) PVC (36) Snail farming (6) Solar hot water (26) Solar photovoltaic panels (7) Stirling Engines (11) Thinking (49) Vermiculture (1) Wind energy (25)
Aquaponics - Swirl filter variation
I need to get solids out of the water for the NFT, but I don't want to remove the solids from the entire system. It's the solids that make everything work.
I thought I'd give this a try.
I took a peanut butter bucket. (We eat a lot of peanut butter)
And drilled a hole in it in the bottom.
The plan is to add water so that it swirls around.
The water on the inside moves slowly and the solids settle in the middle.
Actually I think there is something else going on here, but I'm not sure what it is.
If you put a helium balloon in a car, and put on the brakes, instead of the balloon moving forward like everything else, it rushes to the back of the car. The opposite also applies to acceleration and cornering. As far as I can tell, this happens because, under brakes, the pressure moves to the front. High pressure is like the pressure at ground level, and helium balloons hate being at ground level, so try to escape in the only direction they know how.
But it's not really up, its from high pressure to low pressure. Or in the case of the car, from the front (where all the air in the car is glugging toward) to the back.
Ask a kid with a balloon to try it.
I think something to do with something like that may, or may not, be happening here.
I'll try to find out.
I have both tubes dumping back to the grow bed because this is just a test, but normally only one would go back. The other (top left of the bucket) would be feeding the NFT tubes that you can see under the device in the background.
I'll take some video and post it up tomorrow, and hopefully capture the thing working.
I'm not sure that it will work all that well, because I think it's too small. I think it needs to be wider, to allow the centre to be very slow moving, and deeper, to allow more time for the particles to settle out.
The bell siphon was a clever thing for someone to design, and as such you feel a bit of that "clever" rub off onto you when you m...
You see CHIFT PIST a lot in the aquaponics forums and it means "constant height in fish tank, pump in sump tank". And its a very g...
A "bell siphon" is a device that automates the flooding and draining of an aquaponics grow bed, even though the pump is adding wa...
Painting lures is easier if you don't know how. I don't, so I'm already well on my way. I started by owning a printer. That ...
A while ago I tried to make a fish fed fish feeder design that would allow the fish to feed themselves. I think It's made. I say &q...
Apparently, marron come in two varieties. Hairy and not so hairy. Cherax cainii (smooth) and Cherax tenuimanus, or Margret River marron (hai...
In aquaponics, one issue that can effect your success rate is the pH of your water. pH is a measure of water's (or soil's or whateve...
With a little practice its possible to make a screw. If you bend your wire into an eyelet, its possible to make a screw in eyelet. The use...
I had an idea, but now I'm not sure it was mine after all. But here it is anyway. I need to get solids out of the water for the NFT, ...
This post is a follow up to the " handmade fishing lures how to get most out of your printer " post describing my way to colour ha...